Motor Electronics Cooler

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Motor Electronics Cooler Replacement Components With Torque Specifications

Courtesy of FORD MOTOR CO.

ITEM DESCRIPTION

Item	Part Number	Description
1	8B273	Motor Electronics Cooling System (MECS) radiator inlet hose
2	8B274-B	MECS radiator outlet hose
3	N606676-S	MECS radiator bolts
4	8005-B	MECS radiator

Drain the Motor Electronics Cooling System (MECS). For additional information, refer to MOTOR ELECTRONICS COOLING SYSTEM DRAINING AND FILLING .
Remove the front bumper cover. For additional information, refer to BUMPER -- FRONT .
Loosen the hose clamp and disconnect the MECS radiator inlet hose.

Fig 2: Locating Hose Clamp
Courtesy of FORD MOTOR CO.
Loosen the hose clamp and disconnect the MECS radiator outlet hose.

Fig 3: Locating Hose Clamp
Courtesy of FORD MOTOR CO.

NOTE: RH shown in illustration, LH similar.

Remove the MECS radiator bolts.
- To install, tighten to 6 Nm (53 lb-in).
  
  Fig 4: Removing Motor Electronics (M/E) Cooler Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.