Transaxle Draining and Filling: Material

WARNING: This page is about a different car, the 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

ITEM SPECIFICATION

Item	Specification
SAE 75W-90 API GL-4 Gear Oil XT-4-QGL	WSS-M2C203-A1
Silicone Gasket and Sealant TA-30	WSE-M4G323-A4

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the drain plug and drain the fluid.

Fig 1: Locating Drain Plug
Courtesy of FORD MOTOR CO.

NOTE: Use a new gasket and apply sealant on the drain plug.

Install the drain plug.
- Tighten to 35 Nm (26 lb-ft).
  
  Fig 2: Locating Drain Plug
  Courtesy of FORD MOTOR CO.
Remove the fill level inspection plug.

Fig 3: Locating Fill Level Inspection Plug
Courtesy of FORD MOTOR CO.
Fill the transmission with gear oil through the fill level inspection plug hole, until level with the fill level inspection plug hole.

NOTE: Use a new gasket and apply sealant on the fill level inspection plug.

Install the fill level inspection plug.
- Tighten to 35 Nm (26 lb-ft).
  
  Fig 4: Locating Fill Level Inspection Plug
  Courtesy of FORD MOTOR CO.