Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For component identification and locations, refer to SEAT - EXPLODED VIEW, FRONT .
- Remove the front seat backrest. For additional information, refer to SEAT BACKREST - FRONT .
- Remove the safety belt buckle pretensioner.
- Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
- Detach the wiring harness pin-type retainer.
- Route the wiring harness from between the seat track and cushion frame.
- Disconnect the electrical connectors, detach the wiring harness from the seat track.
- If driver seat, disconnect the seat position sensor electrical connector.
- If equipped, disconnect the power seat motor electrical connector.
- Detach the seat harness electrical connector from the seat track.
- Note wiring harness routing for correct installation.
- Remove the 4 seat track-to-cushion frame bolts.
- To install, tighten to 25 Nm (18 lb-ft).
- To install, reverse the removal procedure.
- Transfer components as necessary.