LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1501 (Instrument Panel And Console) >> Removal And Installation >> Instrument Panel Finish Panel - Center, Middle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL FINISH PANEL - CENTER, UPPER .
  2. Remove the lower instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL FINISH PANEL - CENTER, LOWER .
  3. Remove the 4 middle instrument panel center finish panel screws.
  4. Remove the middle instrument panel center finish panel in the following sequence.
    1. Pull outward to release the retaining clips.
    2. Disconnect the electrical connectors.
  5. To install, reverse the removal procedure.
    • Make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.
scientia non olet · About LEMON Manuals