LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Anti-Lock Brake System -- F250-F550 Super Duty) >> Diagnosis & Testing >> Anti-Lock Control >> Anti-Lock Brake System ABS Diagnostic Trouble Code (DTC) Index

Anti-Lock Brake System ABS Diagnostic Trouble Code (DTC) Index

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
ANTI-LOCK BRAKE SYSTEM ABS DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC Description Source Action
B1317  Battery Voltage High  ABS Module GO to PINPOINT TEST B .
B1318  Battery Voltage Low  ABS Module GO to PINPOINT TEST B .
B1342  ECU is Faulted  ABS Module REPAIR all other DTCs. CLEAR the DTCs. TEST the system for normal operation. If the DTC returns, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE .
B2477  Module Configuration Failure  ABS Module CONFIGURE the ABS module. REFER to MODULE CONFIGURATION . CLEAR the DTCs. REPEAT the self-test. If DTC B2477 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . REPEAT the self-test.
B2900  VIN Mismatch  ABS Module CHECK for the correct VIN number in the VID block of the PCM. CONFIGURE the ABS module. REFER to MODULE CONFIGURATION . Use Programmable Module Installation (PMI) for the ABS module. CLEAR the DTCs. REPEAT the self-test. If DTC B2900 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . REPEAT the self-test.
C110A  ABS Active Circuit Short to Battery  ABS Module If any other DTC(S) are present, diagnose those DTC(s) first. CLEAR all DTC(s). DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1095  ABS Hydraulic Pump Motor Circuit Failure  ABS Module GO to PINPOINT TEST C .
C1096  ABS Hydraulic Pump Motor Circuit Open  ABS Module GO to PINPOINT TEST C .
C1115  ABS Power Relay Output Short Circuit to Battery  ABS Module CLEAR all DTCs. DRIVE the vehicle. If DTC C1115 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1145  Wheel Speed RF Sensor Input Circuit Failure  ABS Module GO to PINPOINT TEST D .
C1155  Speed Wheel Sensor LF Input Circuit Failure  ABS Module GO to PINPOINT TEST D .
C1175  Speed Wheel Sensor Rear Input Circuit Failure  ABS Module GO to PINPOINT TEST D .
C1185  ABS Power Relay Output Circuit Failure  ABS Module CLEAR all DTCs. If DTC C1185 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1194  ABS Outlet Valve Coil LF Circuit Failure  ABS Module CLEAR all DTCs. If DTC C1194 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1198  ABS Inlet Valve Coil LF Circuit Failure  ABS Module CLEAR all DTCs. If DTC C1198 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1210  ABS Outlet Valve Coil RF Circuit Failure  ABS Module CLEAR all DTCs. If DTC C1210 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1214  ABS Inlet Valve Coil RF Circuit Failure  ABS Module CLEAR all DTCs. If DTC C1214 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1222  Wheel Speed Mismatch  ABS Module GO to PINPOINT TEST E .
C1233  Speed Wheel LF Input Signal Missing  ABS Module GO to PINPOINT TEST E .
C1234  Speed Wheel RF Input Signal Missing  ABS Module GO to PINPOINT TEST E .
C1236  Speed Wheel Rear Input Signal Missing  ABS Module GO to PINPOINT TEST E .
C1242  ABS Outlet Valve Coil LR Circuit Failure  ABS Module CLEAR all DTC(s.) DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1246  ABS Outlet Valve Coil RR Circuit Failure  ABS Module CLEAR all DTC(s). DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1250  ABS Inlet Valve Coil LR Circuit Failure  ABS Module CLEAR all DTC(s). DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1254  ABS Inlet Valve Coil RR Circuit Failure  ABS Module CLEAR all DTC(s). DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
C1329  ABS Valve Outlet Coil Over RF Temperature  ABS CLEAR all DTCs. DRIVE the vehicle. IF DTC C1329 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied.
C1330  ABS Valve Outlet Coil Over LR Temperature  ABS CLEAR all DTCs. DRIVE the vehicle. IF DTC C1330 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied.
C1331  ABS Valve Outlet Coil Over RR Temperature  ABS CLEAR all DTCs. DRIVE the vehicle. IF DTC C1331 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied.
C1332  ABS Valve Outlet Coil Over LF Temperature  ABS CLEAR all DTCs. DRIVE the vehicle. IF DTC C1332 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied.
C1333  ABS Valve Inlet Coil Over RF Temperature  ABS CLEAR all DTCs. DRIVE the vehicle. IF DTC C1333 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied.
C1334  ABS Valve Inlet Coil Over LR Temperature  ABS CLEAR all DTCs. DRIVE the vehicle. IF DTC C1334 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied.
C1335  ABS Valve Inlet Coil Over RR Temperature  ABS CLEAR all DTCs. DRIVE the vehicle. IF DTC C1335 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied.
C1336  ABS Valve Inlet Coil Over LF Temperature  ABS CLEAR all DTCs. DRIVE the vehicle. IF DTC C1336 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied.
C1446  Brake Switch Circuit Failure  ABS Module GO to PINPOINT TEST F .
C1730  Reference Voltage Out of Range (+5V)  ABS Module If any other DTC(s) are present, diagnose those DTC(s) first. CLEAR all DTCs. DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
U0073  CAN Bus Off -Transmit Error  ABS Module If any other DTC(s) are present, diagnose those DTC(s) first. CLEAR all DTCs. DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
U1900  CAN Communication Bus Fault-Receive Error  ABS Module REFER to MODULE COMMUNICATIONS NETWORK .
U2050  No Application Present  ABS Module If any other DTC(s) are present, diagnose those DTC(s) first. CLEAR all DTCs. DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.
U2051  One or More Calibration Files Missing/Corrupt  ABS Module If any other DTC(s) are present, diagnose those DTC(s) first. CLEAR all DTCs. DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied.