LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Removal & Installation - A/T) >> Removal & Installation >> Q45 >> Removal

Removal & Installation: Q45: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2000 Infiniti QX4, 2000 Infiniti Q45, 2000 Infiniti I30, 2000 Infiniti G20, and 1999 Infiniti QX4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Ensure crankshaft position sensor is removed before separating transaxle from engine.
  1. Disconnect negative battery cable. Remove crankshaft position sensor from transaxle. Remove fill pipe, oil cooler pipe clamps and oil cooler pipe from transmission assembly. Disconnect rear oxygen sensor harness connectors. Remove exhaust pipes.
  2. Unplug A/T harness and speed sensor connectors. Remove control linkage from selector lever. Plug all openings. Remove drive shaft.
    CAUTION: Insert plug into rear oil seal after removing drive shaft. Ensure no damage occurs to spline, sleeve yoke or rear seal when removing drive shaft.
  3. Remove starter, gusset securing engine to transmission assembly. Mark drive plate in relation to torque converter for installation reference. Remove torque converter-to-drive plate bolts. Support engine/transmission assembly with jack and remove rear mounting bracket from body. Remove bellhousing bolts, and lower transmission assembly from vehicle.
scientia non olet · About LEMON Manuals