LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1494 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: There is no bearing for the stud shaft. There is a seal only.
  1. Remove the halfshaft assembly. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Use the Torque Converter Fluid Seal Remover and Slide Hammer to remove the stub shaft seal.
    Fig 1: Removing Stub Shaft Seal Using Special Tool
    G06065011Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals