LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1494 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new stub shaft seal with grease.
    Fig 1: Identifying Front Axle Oil Seal Installer And Handle
    G06065012Courtesy of FORD MOTOR CO.
  1. Using the Front Axle Oil Seal Installer and Handle, install the stub shaft seal.
    2. NOTE: Inspect the inboard CV joint seal journal for rust or nicks/scratches prior to installing the halfshaft. If necessary, polish the seal journal with fine crocus cloth.
  2. Install the halfshaft assembly. For additional information, refer to REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals