LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1491 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Removal And Installation >> Instrument Cluster (IC) >> Removal

Instrument Cluster (IC): Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If installing a new Instrument Cluster (IC), all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
  1. If installing a new IC  , upload the module configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION .
  2. Lower the tilt steering column to the lowest position.
  3. Pull the IC  finish panel straight out to release the retainer clips and remove the finish panel.
    • Disconnect the instrument panel dimmer switch electrical connector and the ambient air temperature sensor (if equipped).
  4. Remove the 4 IC  screws and the IC  .
    • Disconnect the electrical connector.
scientia non olet · About LEMON Manuals