LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1491 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Principles of Operation >> Warning Chimes >> Warning Chime Characteristics

Warning Chime Characteristics

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Each warning chime has unique characteristics that help to identify and differentiate each warning chime. The warning chimes use volume, chime frequency, length of time the chime sounds and the number of chime tones to identify which chime is sounding. The IC  prioritizes the chimes according to a preset hierarchy programmed into the IC  software. When more than one chime request is received by the IC  , the most important chime sounds. If a lower priority chime is currently sounding, the higher priority request takes over and replaces the lower priority chime.

There are 3 different chimes as listed below:

The following table provides a summary of the chime characteristics.

IC Chime Characteristics 

IC CHIME CHARACTERISTICS CHART

Chime Name Chime Type Condition/Description
Active park assist (if equipped) Single/Repetitive Provides either single or repetitive tones depending on the nature of the message received from the Parking Aid Module (PAM).
Air bag Repetitive Consists of five sets of chimes that make up a chime cycle. Each chime set is five one-second on/one-second off chimes followed by a 5 second delay. There is a 30-minute delay between each cycle of chime sets.
Belt-Minder® A/B Repetitive On for as long as the IC  receives the Belt-Minder® chime request. The chime sounds 6 chime tones/safety belt warning indicator flash sequences for as long as the IC  receives the Belt-Minder® chime request.
Door ajar Single This is a single tone chime that sounds when the key is in the RUN position and a door changes from closed to ajar.
Engine on reminder (hybrid) Repetitive On for 10 seconds with the key in the RUN position and the LH front door ajar.
Hazard signal Repetitive On for as long as the hazard on/off command is received by the IC  .
Headlamps on Repetitive On for as long as the headlamps are on and the IC  receives the chime on command.
Key-in-ignition Repetitive On for as long as the key is in the ignition with the ignition in OFF or ACC and the door ajar, the IC  receives the chime on command and the battery saver has not activated.
Message center (if equipped) Single This is a single tone chime that sounds once per ignition cycle whenever the IC  receives a new message commanding on one of the message center warnings except for the park brake warning.
Parking brake on Repetitive 90 one-second duration tones on for as long as the parking brake is applied and the IC  receives the chime on command.
Safety belt Repetitive On for as long as the safety belt is unbuckled and the IC  receives the chime on command.
Turn signal left on Repetitive On for as long as the RH or LH turn signal is on, the vehicle has travelled 3.2 km (2.0 miles) and the IC  receives the chime on command.
Turn signal Tick-tock On for as long as the RH or LH turn signal command is received by the IC  .