Brake Drum: Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wheel and tire. For additional information, refer to WHEEL AND TIRE .

NOTE: Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.

NOTE: If the brake drum is seized to the wheel hub pilot diameter, tap the center of the brake drum between the wheel studs.

If the brake drum binds on the brake shoes, retract the brake shoes.
1. Move the brake shoe adjuster actuator lever away from the adjuster.
2. Rotate the brake shoe adjuster screw upward to retract the brake shoes.
  
  Fig 1: Identifying Brake Shoe Adjuster Screw And Brake Shoe Adjuster Actuator Lever
  Courtesy of FORD MOTOR CO.
Remove the brake drum.