LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1465 (Manual Transaxle And Clutch - General Information) >> Diagnosis And Testing >> Manual Transaxle and Clutch >> Component Tests >> Clutch Chatter or Shudder

Clutch Chatter or Shudder

WARNING: This page is about a different car, the 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
  2. Inspect the engine and transmission mounts for looseness and damage.
    • If the mounts are OK, proceed to the next step .
    • If the mounts are loose or damaged, tighten or install new mounts as necessary. Test the system for normal operation.
  3. Check for loose bolts that retain the clutch pressure plate to the flywheel.
    • If the bolts are tightened to specification proceed to the next step .
    • If the bolts are loose, tighten the bolts to specification. Refer to SPECIFICATIONS . Test the system for normal operation.
  4. Remove the clutch disc and pressure plate. Refer to REMOVAL AND INSTALLATION . Inspect the clutch disc and pressure plate for wear and damage, and check the clutch disc runout. Refer to CLUTCH DISC CHECK . Inspect the flywheel for glazing and damage. Refer to FLYWHEEL RUNOUT CHECK . Inspect the input shaft for wear, damage and eccentricity. Repair all components as necessary.
scientia non olet · About LEMON Manuals