Turbine Shaft Speed (TSS) Sensor: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Install the TSS sensor, the bolt and connect the TSS electrical connector.
- Tighten to 10 Nm (89 lb-in).
  
  Fig 1: Locating Turbine Shaft Speed (TSS) Electrical Connector And Bolt
  Courtesy of FORD MOTOR CO.
Install the LH splash shield and the retainers.

Fig 2: Locating LH Splash Shield Retainers
Courtesy of FORD MOTOR CO.
Fill with clean transmission fluid to the correct level.