Shift Concerns: No 2-3 Shift (Automatic)

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSTIC ROUTINES REFERENCE

Possible Component	Reference/Action
221 - ELECTRICAL ROUTINE
Powertrain Control System
Electrical inputs/outputs, vehicle wiring harnesses, PCM, Shift Solenoid B (SSB) failed, Shift Solenoid C (SSC) stuck on and Transmission Range (TR) sensor	Run On-Board Diagnostic (OBD). Refer to INTRODUCTION - GASOLINE MODELS for diagnosis. GO to PINPOINT TEST A and GO to PINPOINT TEST D .
321 - HYDRAULIC/MECHANICAL ROUTINE
Incorrect Pressures
Line pressure	Carry out Line Pressure Test. Refer to SPECIAL TESTING PROCEDURES . Check pressure at pressure tap. See the LINE PRESSURE CHART for specifications. If not OK, check main control. Refer to MAIN CONTROL VALVE BODY .
Main Control Valve Body
Bolts out of torque specification	Tighten bolts to specification.
gaskets and separator plate - damaged, off location	Inspect for damage. Install new as required.
Direct regulator and boost valves, springs, clips - loose, stuck, missing, misassembled, stuck off	Inspect for damage. Repair or install new as required.
Intermediate regulator and boost valves, springs, clips - loose, stuck, missing, misassembled, stuck on	Inspect for damage. Repair or install new as required.
SSB or SSC not functioning correctly	Activate solenoid using scan tool. Refer to OUTPUT STATE CONTROL (OSC) MODE . GO to PINPOINT TEST A . Install a new solenoid as required. Refer to SOLENOIDS . Download a new solenoid body strategy into the PCM. Refer to SOLENOID BODY STRATEGY .
Direct Clutch Assembly - Failed Off
Seals - damaged	Inspect for damage. Install new as required.
Piston - damaged	Inspect for damage. Install new as required.
Friction - damaged, worn	Inspect for damage. Install new as required.
Cylinder hub - damaged	Inspect for damage. Install new as required.
Return spring assembly - damaged	Inspect for damage. Install new as required.
Intermediate Clutch Assembly - Failed On
Seals - damaged	Inspect for damage. Install new as required.
Piston - damaged	Inspect for damage. Install new as required.
Friction - damaged, worn	Inspect for damage. Install new as required.
Cylinder hub - damaged	Inspect for damage. Install new as required.
Return spring assembly - damaged	Inspect for damage. Install new as required.