LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1460 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Valve Spring, Retainer, and Seal >> Installation

Valve Spring, Retainer, and Seal: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the valve guide with clean engine oil.
    Fig 1: Identifying Valve Stem Oil Seal Installer
    G06389370Courtesy of FORD MOTOR CO.
  1. Using the Valve Stem Oil Seal Installer, install the valve seal.
  2. Using the Valve Spring Compressor, install the valve spring, retainer and key.
    Fig 2: Identifying Valve Spring Compressor
    G06389371Courtesy of FORD MOTOR CO.
  3. Install the camshaft roller followers. For additional information, refer to CAMSHAFT ROLLER FOLLOWER .
scientia non olet · About LEMON Manuals