LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1459 (Engine Mechanical - 2.5L (Except Hybrid)) >> In-Vehicle Repair >> Valve Cover >> Installation

Valve Cover: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths.
  1. Clean and inspect the sealing surfaces.
    2. NOTE: The valve cover must be secured within 4 minutes of silicone gasket application. If the valve cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with metal surface prep.
    Fig 1: Locating Silicone Gasket And Sealant Applying Locations
    G06094839Courtesy of FORD MOTOR CO.
  2. Apply silicone gasket and sealant to the locations shown.
    3. NOTE: Clean and inspect the gasket. Install a new gasket, if necessary.
  3. Install the valve cover, gasket and retainers.
    • Tighten in the sequence shown to 10 Nm (89 lb-in).
      Fig 2: Identifying Valve Cover Bolts Tightening Sequence
      G06094840Courtesy of FORD MOTOR CO.
  4. Position the wiring harness and attach all of the wiring harness retainers to the valve cover studs.
  5. Connect the VCT  solenoid electrical connector.
  6. Connect the radio capacitor electrical connector.
  7. Connect the CMP  sensor electrical connector.
  8. Connect the CHT  sensor electrical connector.
  9. Connect the crankcase vent hose.
  10. Install the ignition coil-on-plugs. For additional information, refer to ENGINE IGNITION - 2.5L .
  11. Install the oil level indicator.
scientia non olet · About LEMON Manuals