LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1451 (Exterior Trim & Ornamentation) >> Removal And Installation >> Applique - Luggage Compartment Lid >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the luggage compartment lid trim panel pin-type retainers.
  2. Remove the luggage compartment lid trim panel.
  3. Disconnect the luggage compartment lid applique electrical connectors.
  4. Remove the luggage compartment lid applique nuts.
    • To install, tighten to 5 Nm (44 lb-in).
  5. Remove the luggage compartment lid applique.
    • Squeeze the tabs on the luggage compartment lid applique pin-type retainer to release it from the luggage compartment lid.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals