Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: On the MKZ, there is an outer lighted scuff plate. For additional information, refer to Removal and Installation .

Pull the front inboard section of the scuff plate trim panel outward to release the 1 retaining clip.
Lift the scuff plate trim panel straight up to release the scuff plate trim panel from the 3 retaining clips.
NOTE: The 3 retaining clips must stay attached to the door weather strip and pinch weld.
To install, reverse the removal procedure.
- Align the scuff plate trim panel into the clips and snap into place.