Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The A-pillar trim panel is a one-time-use. If removed, a new A-pillar trim panel must be installed.

Remove the A-pillar trim panel and the clip from the sheet metal.
NOTE: When removing the A-pillar trim panel, use a gentle side-to-side rocking motion to free the clip from the trim panel.
To install, reverse the removal procedure.
- Align attachment clips to the holes and snap the new A-pillar trim panel in place.