Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear bumper cover. For additional information, Refer to REMOVAL AND INSTALLATION .
Disconnect the parking aid sensor(s) electrical connector(s).
Pry the retaining tabs with a suitable tool, such as a flat bladed screwdriver and remove the parking aid sensor(s).
To install, reverse the removal procedure.

Carry out the azimuth and elevation system check. For additional information, Refer to AZIMUTH SYSTEM CHECK and ELEVATION SYSTEM CHECK .