LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1447 (Parking Aid System) >> Diagnosis And Testing >> Parking Aid >> Principles of Operation

Principles of Operation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Smart Junction Box (SJB) is also known as the Generic Electronic Module (GEM).

The parking aid sensors detect objects approximately 152 cm (60 in) from the rear of the vehicle, 50 cm (1.6 ft) from the rear side of the vehicle, and 30 cm (12 in) above the ground. The Parking Aid Module (PAM) calculates the distance to an object within the 170 degree semicircular area around the rear of the vehicle. A variable warning tone is generated from a parking aid speaker. The parking aid speaker increases its warning tone rate as the vehicle gets closer to an obstacle. When an object is detected within 25 cm (10 in) of the sensors, the warning tone becomes continuous.

The parking aid speaker has a dual function for vehicles equipped with the parking aid system and cross traffic alert system. The parking aid speaker will emit an audible warning tone to notify the driver of impeding traffic from the side of the vehicle when backing out of parking spaces. Refer to CROSS TRAFFIC ALERT (CTA) for cross traffic alert information.

The parking aid system is enabled when the ignition switch is in the RUN position and the REVERSE (R) gear is selected. The parking aid system is disabled if a fault is detected in 1 of the 3 sensors, the parking aid speaker, or the PAM  . This is indicated by a warning and the message center will display the message "CHECK PARK AID".

The PAM  is on the Medium Speed Controller Area Network (MS-CAN) and can be diagnosed with a scan tool. The PAM  communicates with the scan tool, the Audio Control Module (ACM), the SOD-L  , the SOD-R  and the Instrument Panel Cluster (IPC). The following chart describes network messages used by the PAM  :

NOTE: Both the MS-CAN  and the High Speed Controller Area Network (HS-CAN) are used for intermodule communication. A gateway message is transferred from one network to another network through the IPC  . Refer to COMMUNICATIONS NETWORK and/or COMMUNICATIONS NETWORK -- HYBRID for network communication information.
PAM NETWORK COMMUNICATION MESSAGES TABLE

Broadcast Message Originating Module Network Type Receiving Module
Ignition switch position IPC  MS-CAN  PAM 
Parking aid sounder volume cutback request PAM  MS-CAN  ACM 
Parking aid enabled status IPC  MS-CAN  PAM 
Parking aid system status PAM  MS-CAN  IPC 
Transmission selector (PRNDL) range (gateway) IPC  MS-CAN  PAM 
Side obstacle detection cross traffic alert SOD-L  and SOD-R  MS-CAN  PAM 
Vehicle speed (gateway) IPC  MS-CAN  PAM