LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1409 (Engine Cooling System (Hybrid)) >> Removal And Installation >> Cooling Fan Motor and Shroud >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. If equipped, detach the 2 block heater wiring retainers from the cooling fan motor and shroud.
  3. Remove the splash shield.
    Fig 1: Locating Splash Shield
    G06272329Courtesy of FORD MOTOR CO.
  4. Detach the lower radiator hose pin-type retainer from the cooling fan motor and shroud.
  5. Remove the battery tray. For additional information, refer to REMOVAL AND INSTALLATION .
  6. Remove the 2 bolts and position the auxiliary relay box aside.
    • To install, tighten to 8 Nm (71 lb-in).
  7. Detach all the wiring harness retainers from the cooling fan and shroud.
  8. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
  9. Disconnect the cooling fan electrical connector.
  10. Release the 2 tabs and remove the cooling fan motor and shroud.
    NOTE: LH shown in illustration, RH similar.
    Fig 2: Locating Tabs, Cooling Fan Motor & Shroud
    G06272330Courtesy of FORD MOTOR CO.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals