LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1406 (Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid)) >> General Procedures >> Selector Lever Knob >> Removal

Selector Lever Knob: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles equipped with a 2.5L engine 

  1. Remove the selector lever trim ring.
    Fig 1: Locating Selector Lever Trim Ring
    G06275641Courtesy of FORD MOTOR CO.
  2. Remove the center console trim panel.
    Fig 2: Locating Center Console Trim Panel
    G06275642Courtesy of FORD MOTOR CO.
  3. Disconnect the Transmission Control Switch (TCS) electrical connector.
    Fig 3: Locating Transmission Control Switch Electrical Connector
    G06275702Courtesy of FORD MOTOR CO.

    All vehicles 

  4. Slide the selector lever knob bezel downward to gain access to the 2 selector lever knob screws.
    NOTE: Fusion/Milan shown in illustration, MKZ similar.
    Fig 4: Sliding Selector Lever Knob Bezel Downward To Gain Access
    G06275736Courtesy of FORD MOTOR CO.
  5. Remove the 2 screws from the selector lever knob. Remove the selector lever knob and selector lever knob bezel.
    NOTE: For vehicles equipped with a 2.5L engine, it is necessary to route the Transmission Control Switch (TCS) harness out of the selector lever bezel when removing the selector lever knob.
    NOTE: Fusion/Milan shown in illustration, MKZ similar.
    Fig 5: Locating Selector Lever Knob & Bezel
    G06275704Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals