Selector Lever Bezel - MKZ: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the LH and RH console finish moldings.

Fig 1: Locating Console Finish Moldings
Courtesy of FORD MOTOR CO.
Slide the selector lever knob lower bezel down to expose the 2 selector lever knob screws.

Fig 2: Sliding Selector Lever Knob Lower Bezel Down
Courtesy of FORD MOTOR CO.
Remove the 2 selector lever knob screws and remove the selector lever knob.

Fig 3: Locating Selector Lever Knob Screws
Courtesy of FORD MOTOR CO.
Lift the arm rest, apply the emergency brake, pull directly up on the selector lever bezel and remove it from the center console.

Fig 4: Locating Emergency Brake Lever
Courtesy of FORD MOTOR CO.
Disconnect the selector lever bezel electrical connector and remove the selector lever bezel.

Fig 5: Locating Selector Lever Bezel Electrical Connector
Courtesy of FORD MOTOR CO.
Compress the retention tabs on the selector lever boot and remove the boot from the bottom of the selector lever bezel.

Fig 6: Compressing Retention Tabs On Selector Lever Boot
Courtesy of FORD MOTOR CO.
Compress the retention tabs on the selector lever trim ring and remove the trim ring through from the top of the selector lever bezel.

Fig 7: Compressing Retention Tabs On Selector Lever Trim Ring

Courtesy of FORD MOTOR CO.