LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1403 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Luggage Compartment Lid Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 10 pin-type retainers and the luggage compartment lid trim panel.
  2. Disconnect the luggage compartment lid lock cylinder actuating cable from the luggage compartment lid lock cylinder.
  3. Disconnect the electrical connector from the luggage compartment lid latch.
  4. Remove the 3 nuts and the luggage compartment lid latch.
    • To install, tighten to 9 Nm (80 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals