LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1403 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch Release Handle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hood latch. For additional information, refer to Removal and Installation .
  2. Remove the LH fender splash shield. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Release the 2 hood latch release cable locators from the radiator grille opening panel reinforcement.
  4. Disconnect the hood latch release cable from the LH fender opening, open the 2 hood latch release cable locators and position the cable aside.
  5. Release the hood latch release cable locator from the wiring harness.
  6. Remove the Smart Junction Box (SJB). For additional information, refer to INSTALLATION .
  7. Remove the 2 hood latch release handle bolts.
  8. Remove the hood latch release handle and cable assembly.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals