LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Seat System - Seats) >> Removal And Installation >> Seat Bolster - Rear >> Installation

Seat Bolster - Rear: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the side bolster, align and insert to the latch.
    NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
  2. Align the bolt holes and install the side bolster bolt.
    • Tighten to 11 Nm (97 lb-in).
  3. Install the rear seat cushion. Refer to SEAT CUSHION - REAR .
scientia non olet · About LEMON Manuals