Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Recover the refrigerant. For additional information, refer to REFRIGERANT SYSTEM RECOVERY .
- Remove the A/C pressure relief valve and O-ring seal.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
- Add the correct amount of clean PAG refrigerant oil to the refrigerant system. For additional information, refer to REFRIGERANT OIL ADDING .
NOTE: A new O-ring seal will already be installed on the new A/C pressure relief valve service part. - Evacuate, leak test and charge the refrigerant system. For additional information, refer to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .