LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Automatic Transmission -- F250-F550 Super Duty) >> In-Vehicle Repair >> Solenoid Body Assembly >> Installation

Solenoid Body Assembly: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new solenoid body gasket.
    Fig 1: Installing Solenoid Body Gasket
    G03889054Courtesy of FORD MOTOR CO.
  2. Using the special tools, install the solenoid body and loosely install the bolts.
    • While installing the solenoid body, align the manual valve.
      Fig 2: Installing Solenoid Body
      G03889056Courtesy of FORD MOTOR CO.
  3. Tighten all the bolts in the sequence shown.
    Fig 3: Identifying Solenoid Body Bolt Tightening Sequence
    G03889057Courtesy of FORD MOTOR CO.
  4. Connect the transmission range sensor connector.
    Fig 4: Connecting Transmission Range Sensor Connector
    G03889058Courtesy of FORD MOTOR CO.
  5. Install the transmission fluid filter, pan gasket and pan.
  6. Connect the solenoid body electrical connector.
    Fig 5: Solenoid Body Electrical Connector - With Torque Specification
    G03889059Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals