LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Automatic Transmission -- F250-F550 Super Duty) >> In-Vehicle Repair >> Extension Housing Seal >> Removal

Extension Housing Seal: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT .

    2. 4x4 vehicles 

  2. Remove the transfer case. For additional information, refer to TRANSFER CASE .

    3. Vehicles with a fixed flange 

  3. Remove the output shaft flange.
    1. Remove and discard the output shaft flange bolt.
    2. Remove the output shaft flange.
      Fig 1: Removing Output Shaft Flange
      G03889089Courtesy of FORD MOTOR CO.
  4. Using the special tool, remove and discard the output shaft nut.
    Fig 2: Removing Output Shaft Nut Using Special Tool
    G03889090Courtesy of FORD MOTOR CO.
  5. Using the special tools, remove the output shaft seal.
    Fig 3: Removing Output Shaft Seal
    G03889091Courtesy of FORD MOTOR CO.

    6. Vehicles without a fixed flange 

  6. Using the special tools, remove the extension housing seal.
    Fig 4: Removing Extension Housing Seal
    G03889092Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals