LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Automatic Transmission -- F250-F550 Super Duty) >> In-Vehicle Repair >> Extension Housing Gasket - 4X2 >> Removal

Extension Housing Gasket - 4X2: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT .

    2. Vehicles equipped with a fixed flange 

  2. Remove the output shaft flange.
    1. Remove and discard the output shaft flange bolt.
    2. Remove the output shaft flange.
      Fig 1: Removing Output Shaft Flange
      G03889089Courtesy of FORD MOTOR CO.

    3. All vehicles 

  3. Remove the transmission rear crossmember support insulator nuts.
    Fig 2: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  4. Install a suitable transmission jack.
  5. Remove the transmission rear crossmember support insulator bolts.
    Fig 3: Identifying Transmission Support Insulator Bolts
    G03889100Courtesy of FORD MOTOR CO.
  6. Remove the rear transmission mount.
    1. Raise the transmission upward, from the rear crossmember support.
    2. Remove the rear transmission mount.
      Fig 4: Removing Rear Transmission Mount
      G03889101Courtesy of FORD MOTOR CO.
  7. Disconnect the output shaft speed (OSS) sensor electrical connector.
    Fig 5: Identifying Output Shaft Speed (OSS) Sensor Electrical Connector
    G03889074Courtesy of FORD MOTOR CO.

    8. Vehicles equipped with a fixed flange 

  8. Using the special tool, remove and discard the output shaft nut.
    Fig 6: Removing Output Shaft Nut Using Special Tool
    G03889090Courtesy of FORD MOTOR CO.
  9. Remove the bolts and the transmission extension housing.
    Fig 7: Identifying Extension Housing Bolts
    G03889104Courtesy of FORD MOTOR CO.

    10. Vehicles not equipped with a fixed flange 

  10. Remove the bolts and the transmission extension housing.
    Fig 8: Removing Bolts And Transmission Extension Housing
    G03889105Courtesy of FORD MOTOR CO.

    11. All vehicles 

  11. Remove and discard the extension housing gasket.
    Fig 9: Identifying Extension Housing Gasket
    G03889106Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals