LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Engine Cooling System (Except Hybrid)) >> Removal And Installation >> Coolant Pump Housing - 3.0L (4V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to Draining .
  2. Remove the Throttle Body (TB). For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the coolant pump belt. For additional information, refer to REMOVAL .
  4. Disconnect the upper radiator hose from the coolant pump housing.
  5. Disconnect the lower radiator hose from the thermostat housing.
  6. Disconnect both heater hoses from the coolant pump housing.
  7. Remove the 2 coolant inlet pipe bolts.
    • To install, tighten to 10 Nm (89 lb-in).
  8. Remove the 3 bolts, 2 nuts and the coolant pump housing.
    • Remove and discard the O-ring seals and gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  9. To install, reverse the removal procedure.
    • Install new O-ring seals and gasket.
  10. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals