LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1390 (Instrument Panel And Console) >> Removal And Installation >> Instrument Cluster Finish Panel - MKZ >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the 2 instrument cluster finish panel screws covers and remove the 2 instrument cluster finish panel screws.
  2. Remove the steering wheel. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the multifunction switch. For additional information, refer to REMOVAL AND INSTALLATION .
  4. Remove the LH instrument panel finish panel.
    • Pull the LH instrument panel finish panel toward the rear of the vehicle to release the retaining clips.
  5. Remove the instrument cluster finish panel.
    • Pull the instrument cluster finish panel toward the rear of the vehicle to release the retaining clips.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals