LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1382 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Rear Drive Unit (RDU) does not have stub shaft pilot bearings. It has stub shaft seals only.
  1. Remove the halfshaft. For additional information, refer to REMOVAL .
  2. Using the Torque Converter Fluid Seal Remover and Slide Hammer, remove the stub shaft seal.
Fig 1: Identifying Torque Converter Fluid Seal Remover & Slide Hammer
G06065011Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals