LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1380 (Transfer Case - Power Transfer Unit (PTU)) >> In-Vehicle Repair >> Cover Seal >> Removal

Cover Seal: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Power Transfer Unit (PTU) may leak different color fluids, red oil leak for automatic transmission fluid and brown/black gear lube for PTU fluid. The PTU seals prevent these types of fluids from leaking. It is important to note which color fluid is leaking to determine the most appropriate service procedure. This procedure will correct a brown/black (gear lube) leak from the RH side of the PTU. For additional information, refer to ANALYSIS OF LEAKAGE .
NOTE: This procedure is to be performed through the RH wheel opening. It is not necessary to remove the exhaust components to complete this repair.
  1. Remove the intermediate shaft seal and deflector. For additional information, refer to Removal .
  2. Remove the cover seal using the Slide Hammer, the extension from the Halfshaft Remover and a suitable seal puller inserted into the groove of the seal.
    NOTE: There is a bearing inside the PTU directly behind the cover seal. The bearing is not serviced.
    Fig 1: Removing Cover Seal Using Slide Hammer
    G06064378Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals