LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Engine - 6.0L Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery LH and RH ground cable(s). For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the cooling fan stator - 6.0L diesel engine. For additional information, refer to ENGINE COOLING .

    4. Vehicles with dual generator 

  4. Remove the dual generator accessory drive belt.
    Fig 1: Rotating Drive Belt Tensioner Clockwise
    G03887086Courtesy of FORD MOTOR CO.
  5. Remove the bolts and the dual generator pulley.
    Fig 2: Removing Bolts And Dual Generator Pulley
    G03887210Courtesy of FORD MOTOR CO.

    6. All vehicles 

  6. Remove the accessory drive belt.
    Fig 3: Rotating Accessory Drive Belt Tensioner Clockwise
    G03906750Courtesy of FORD MOTOR CO.
  7. Check the crankshaft vibration damper runout.
    • Remove the paint from the face of the crankshaft vibration damper at 4 points 90 degrees apart.
    • Attach the special tool to the cylinder block. Position the special tool on one of the unpainted surfaces.
    • Using a suitable tool, pry the crankshaft forward. Zero the dial indicator.
      • NOTE: Pry the crankshaft forward only to eliminate possible error caused by crankshaft end play.
    • Rotate the crankshaft 90 degrees. Pry the crankshaft forward. Record the measurement. Repeat at each unpainted surface.
      • If the runout exceeds specification, install a new crankshaft vibration damper.
        Fig 4: Checking Crankshaft Vibration Damper Runout Using Special Tool
        G03906845Courtesy of FORD MOTOR CO.
    8. WARNING: To avoid personal injury, support the vibration damper during mounting bolt removal. The damper can slide off the nose of the crankshaft very easily.
  8. Remove the bolts and the crankshaft vibration damper.
    • Discard the bolts.
      Fig 5: Removing Crankshaft Bolts
      G03887213Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals