LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Engine - 6.0L Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Pulley >> Installation

Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

    CAUTION: To prevent engine damage, you must always install 4 new bolts when installing the vibration damper.
    NOTE: Do not use anti-seize compounds, grease or any lubricants. Lubricants have an adverse effect on the torque results.
    NOTE: To prevent the crankshaft vibration damper from turning during tightening, install 2 bolts in the outer crankshaft vibration damper bolt holes and hold with a pry bar.
  1. Install the crankshaft vibration damper and bolts.
    • Tighten in the sequence shown.
    • Tighten to 68 Nm (50 lb-ft).
    • Tighten an additional 90 degrees.
      Fig 1: Tightening Crankshaft Vibration Bolts
      G03887214Courtesy of FORD MOTOR CO.
  2. Install the accessory drive belt.
    Fig 2: Rotating Accessory Drive Belt Tensioner Clockwise
    G03906750Courtesy of FORD MOTOR CO.

    3. Vehicles with dual generator 

  3. Install the dual generator pulley and bolts.
    Fig 3: Installing Dual Generator Pulley And Bolts
    G03887216Courtesy of FORD MOTOR CO.
  4. Install the dual generator accessory drive belt.
    Fig 4: Rotating Drive Belt Tensioner Clockwise
    G03887086Courtesy of FORD MOTOR CO.

    5. All vehicles 

  5. Install the cooling fan stator - 6.0L diesel engine. For additional information, refer to ENGINE COOLING .
  6. Connect the LH and RH battery ground cables.
scientia non olet · About LEMON Manuals