Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
PART NUMBER DESCRIPTION TABLE
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Electrical connector (part of 14A005) |
| 2 | W706840 | 4X4 control module nuts and washers (2 required) |
| 3 | 7E453 | 4X4 control module and bracket assembly |
- From below the LH side instrument panel, disconnect the 4X4 control module harness connector.
- Remove the two 4X4 control module nuts.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the 4X4 control module and bracket.
- To install, reverse the removal procedure.