LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1364 (Accessory Drive System - 3.5L) >> Removal And Installation >> Power Steering Pump Belt >> Installation

Power Steering Pump Belt: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering belt on the crankshaft pulley.
  2. Position the power steering belt around the Stretchy Belt Installer Tool and the power steering pulley. Make sure the belt is engaged with the power steering pulley and rotate the crankshaft clockwise to install the power steering belt.
    NOTE: After installation, make sure the belt is correctly seated on the crankshaft and power steering pulleys.
    Fig 1: Positioning Power Steering Belt Around Stretchy Belt Installer Tool & Power Steering Pulley
    G06272442Courtesy of FORD MOTOR CO.
  3. Position the accessory drive belt on the crankshaft pulley.
  4. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
    NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
  5. Install the RH splash shield and the 6 pin-type retainers.
  6. Position the RH fender splash shield and install the 4 screws.
Fig 2: Locating RH Fender Splash Shield Screws
G06257214Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals