Electronic Manual Temperature Control (EMTC) System

The EMTC  system heats or cools the vehicle depending on the control panel selection.

• The control panel selections determine heating or cooling, air distribution and enables blower motor operation.
• The temperature control setting determines the air temperature.
• The blower motor switch varies the blower motor speed.
• During A/C operation the system also reduces the relative humidity of the air.

The EMTC  system operation is determined by the settings on the climate controls. To control the various functions, the EMTC  system is composed of the following:

• HVAC module
• Blower motor resistor
• Defrost/panel/floor mode door actuator
• Air inlet mode door actuator
• Temperature blend door actuator
• Evaporator temperature sensor
• Ambient air temperature sensor

The blower motor switch:

• sets the blower motor speed.
• is serviced only with the HVAC module.

The A/C request button:

• can command the A/C compressor ON when the function selector switch is in PANEL, FLOOR/PANEL, FLOOR/DEFROST and FLOOR when the A/C request switch is pressed. Indicator illuminates when A/C request switch is toggled ON.
• indicator illuminates when the function selector switch is in MAX A/C and cannot be toggled.
• is serviced only with the HVAC module.

The function selector:

• selects airflow direction.
• is serviced only with the HVAC module.

The temperature selector:

• selects full warm and full cool as well as blended outlet temperatures.
• is serviced only with the HVAC module.

The air recirculation button:

• selects either recirculated or outside air source.
• recirculates air in any mode except DEFROST, if requested.
• is disabled in MAX A/C or OFF mode where recirculated air only is used.
• is disabled in DEFROST mode where outside air only is used.
• is serviced only with the HVAC module.