24,000 km (15,000 mi)
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Change engine oil and install a new oil filter.
- Perform multi-point inspection (recommended).
- Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only be rotated if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.
- Install a new cabin air filter (if equipped).
- Inspect automatic transmission fluid level (if equipped with an underhood fluid level indicator).
- Inspect and lubricate control arms, steering linkage, steering ball joints, U-joints and driveshaft with zerk fittings (if equipped).
- Inspect halfshaft boots (if equipped).
- Inspect and lubricate 4WD front axle shaft U-joints (if equipped).
- Inspect brake pads, rotors, brake linings, drums, brake lines, hoses and parking brake system.
- Inspect engine cooling system and hoses.
- Inspect exhaust system and heat shields.
- Check the rear spring U-bolt nuts for correct torque every 24,000 km (15,000 mi) (Transit Connect).