LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Electronic Engine Control System -- Gasoline Engines -- F250-F550 Super Duty) >> Removal And Installation >> Engine Oil Pressure (EOP) Sensor - 5.4L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Disconnect the engine oil pressure (EOP) sensor electrical connector.
  4. Remove the EOP sensor.
    • To install, tighten to 18 Nm (13 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals