LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1349 (Manual Transaxle And Clutch - General Information) >> General Procedures >> Clutch Disc Check >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL SPECIFICATION TABLE

G06275811Courtesy of FORD MOTOR CO.
 Dial Indicator Gauge with Holding Fixture 100-D002 (D78P-4201-B) or equivalent
  1. Check the clutch disc lining surface for hardening, the presence of oil or grease.
  2. Check for a worn clutch disc lining. Measure the minimum allowable depth to the rivet heads with a slide caliper.
    • If the measurement is less than the minimum, install a new clutch disc.
    Fig 1: Measuring Minimum Allowable Depth To Rivet Heads With Slide Caliper
    G06275812Courtesy of FORD MOTOR CO.
  3. Check for loose clutch disc lining rivets.
    • Install a new clutch disc as necessary.
  4. Check the clutch disc for cracking, scoring, discoloration or other surface marks.
    • Install a new clutch disc if necessary.
  5. Using the Dial Indicator Gauge with Holding Fixture, check the maximum allowable runout of the clutch disc.
    • If the runout exceeds the maximum, install a new clutch disc.
    Fig 2: Checking Maximum Runout Of Clutch Disc
    G06275813Courtesy of FORD MOTOR CO.
  6. Use an emery cloth to remove minor imperfections in the clutch disc lining surface.
  7. Check for wear or rust on the splines. If necessary, clean them with an emery cloth.
scientia non olet · About LEMON Manuals