Halfshaft Seal - RH, Front Wheel Drive (FWD): Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the front RH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS .
Using a suitable awl, poke a small hole in the halfshaft seal.

Fig 1: Installing Awl In Halfshaft Seal
Courtesy of FORD MOTOR CO.
Using a suitable dent puller, remove the halfshaft seal.

Fig 2: Removing Halfshaft Seal Using Suitable Dent Puller

Courtesy of FORD MOTOR CO.