LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1346 (Automatic Transaxle - AISIN Aw21) >> In-Vehicle Repair >> Differential Seals - LH >> Installation

Differential Seals - LH: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new differential fluid seal in place.
    Fig 1: Positioning Differential Fluid Seal
    G06263974Courtesy of FORD MOTOR CO.
  2. Using the Output Shaft Seal Installer, install the outer differential fluid seal.
    Fig 2: Installing Outer Differential Fluid Seal
    G06263975Courtesy of FORD MOTOR CO.
  3. Install the LH halfshaft. For additional information, refer to INSTALLATION .
  4. With the transaxle in PARK, the vehicle on a level surface, the engine at idle (680-780 rpm) and foot pressed on the brake, move the selector lever through each gear and allow engagement of each gear. Place the selector lever back in the PARK position.
  5. Wipe the transmission fluid level indicator cap and remove the transmission fluid level indicator.
  6. Wipe the transmission fluid level indicator with a clean cloth.
  7. If transmission fluid needs to be added, add transmission fluid in 0.25L (1/2 pt) increments through the transmission fluid fill plug located on the top of the transaxle near the transmission fluid level indicator. Do not overfill the transmission fluid. Install the transmission fluid level indicator back in the transmission fluid filler tube until it is fully seated, then remove the transmission fluid level indicator. The transmission fluid level should be at the uppermost mark on the transmission fluid level indicator. Only fill to the uppermost mark on the transmission fluid level indicator. Do not overfill. Damage to the transaxle will occur.
    NOTE: In order to get an accurate transmission fluid level reading, the vehicle should be on a level surface. Idle the engine to reach the normal operating temperature. Using the scan tool, verify that the transaxle is at normal operating temperature 60°C-70°C (140°F-158°F), prior to adjusting the transmission fluid level.
    Fig 3: Locating Transmission Fluid Cooler Tubes To Transaxle
    G06263967Courtesy of FORD MOTOR CO.
  8. Fill the transaxle to the correct transmission fluid level.
    NOTE: The correct transmission fluid level at normal operating temperature of 60°C-70°C (140°F-158°F) is between the top 2 marks on the transmission fluid level indicator.
    Fig 4: Locating Transmission Fluid Level Indicator Marks
    G06263968Courtesy of FORD MOTOR CO.
  9. If the Transmission Fluid Temperature (TFT) is low, fill the transaxle with transmission fluid to the cold range on the transmission fluid level indicator. Recheck the transmission fluid level when the transaxle has reached the normal operating temperature.
    NOTE: The correct transmission fluid level at cold operating temperature of 15°C-25°C (59°F-77°F) is at the bottom mark on the transmission fluid level indicator.
    Fig 5: Locating Transmission Fluid Level Indicator Marks
    G06263969Courtesy of FORD MOTOR CO.
  10. Remove the transmission fluid fill plug.
    Fig 6: Locating Transmission Fluid Fill Plug
    G06263965Courtesy of FORD MOTOR CO.
  11. Fill the transaxle with clean transmission fluid.
  12. Install the transmission fluid fill plug.
    • Tighten to 39 Nm (29 lb-ft).
      • Fig 7: Locating Transmission Fluid Fill Plug
      G06263965Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals