LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1345 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Valve Cover >> Removal

Valve Cover: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the ignition coil-on-plugs. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Disconnect the crankcase vent hose from the valve cover.
  4. Detach the 2 block heater wiring harness retainers (if equipped) and the 2 high voltage wiring harness retainers from the valve cover studs.
  5. Remove the 4 engine cover studs.
  6. Position the heater tube assembly off the valve cover stud bolts.
  7. Detach the 3 wire harness retainers from the valve cover and stud bolts.
  8. Disconnect the Camshaft Position (CMP) sensor electrical connector.
  9. Disconnect the Cylinder Head Temperature (CHT) sensor electrical connector.
  10. Disconnect the Variable Camshaft Timing (VCT) solenoid electrical connector.
  11. Remove the oil level indicator.
  12. Remove the 14 valve cover retainers, the valve cover and gasket.
scientia non olet · About LEMON Manuals