LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1345 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Oil Pump Screen and Pickup Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the oil pan. For additional information, refer to Oil Pan, Oil Pump Screen and Pickup Tube  and Removal .
  3. Remove the 2 bolts and the oil pump screen and pickup tube.
    • To install, tighten to 10 Nm (89 lb-in).
    NOTE: Discard the gasket and clean and inspect the gasket mating surfaces.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals