LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1345 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the flywheel. For additional information, refer to Removal .
  3. Drain the engine oil.
    • Install the drain plug.
    • Tighten to 28 Nm (21 lb-ft).
  4. Remove the 17 bolts and the oil pan.
    NOTE: If the oil pan is not removed, damage to the rear oil seal retainer joint can occur.
  5. Remove the 6 bolts and the crankshaft rear oil seal with retainer plate.
scientia non olet · About LEMON Manuals