Special Tool(s)

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOL TABLE

Courtesy of FORD MOTOR CO.

Tool, Camshaft Holding 303-1248

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

NOTE: On early build engines, the timing chain rides on the inner side of the RH timing chain guide. Late build engines are equipped with a different design RH timing chain guide that requires the timing chain to ride on the outer side of the RH timing chain guide. For service, all replacement RH timing chain guides will be the late build design.

All vehicles

Remove the engine front cover. For additional information, refer to Removal and Installation .
Engines equipped with early build RH timing chain guides
Rotate the crankshaft clockwise and align the timing marks on the Variable Camshaft Timing (VCT) assemblies as shown in illustration.

Fig 1: Locating Timing Marks On Variable Camshaft Timing (VCT)
Courtesy of FORD MOTOR CO.

Engines equipped with late build/replacement RH timing chain guides
Rotate the crankshaft clockwise and align the timing marks on the VCT assemblies as shown in illustration.

Fig 2: Locating Timing Marks On Variable Camshaft Timing (VCT) Assemblies
Courtesy of FORD MOTOR CO.

All vehicles
Install the Camshaft Holding Tool onto the flats of the LH camshafts.
NOTE: The Camshaft Holding Tool will hold the camshafts in the Top Dead Center (TDC) position.

Fig 3: Identifying Camshaft Holding Tool
Courtesy of FORD MOTOR CO.
Install the Camshaft Holding Tool onto the flats of the RH camshafts.
NOTE: The Camshaft Holding Tool will hold the camshafts in the TDC position.

Fig 4: Installing Camshaft Holding Tool
Courtesy of FORD MOTOR CO.
Remove the 3 bolts and the RH VCT housing.

Fig 5: Locating VCT Housing Bolts
Courtesy of FORD MOTOR CO.
Remove the 3 bolts and the LH VCT housing.

Fig 6: Locating VCT Housing Bolts
Courtesy of FORD MOTOR CO.
Remove the 2 bolts and the primary timing chain tensioner.

Fig 7: Locating Primary Timing Chain Tensioner Bolts
Courtesy of FORD MOTOR CO.
Remove the primary timing chain tensioner arm.

Fig 8: Locating Primary Timing Chain Tensioner Arm
Courtesy of FORD MOTOR CO.
Remove the 2 bolts and the lower LH primary timing chain guide.

Fig 9: Locating Lower LH Primary Timing Chain Guide & Bolts
Courtesy of FORD MOTOR CO.
Remove the primary timing chain.

Fig 10: Locating Primary Timing Chain
Courtesy of FORD MOTOR CO.
Remove the crankshaft timing chain sprocket.

Fig 11: Locating Crankshaft Timing Chain Sprocket
Courtesy of FORD MOTOR CO.
Remove the 2 oil pump screen and pickup tube bolts.

Fig 12: Locating Oil Pump Screen & Pickup Tube Bolts
Courtesy of FORD MOTOR CO.
Remove the 3 oil pump bolts.
- Rotate the oil pump clockwise and separate the oil pump from the oil pump screen and pickup tube.
- Remove the oil pump.
- Discard the oil pump screen and pickup tube O-ring seal.
Fig 13: Locating Oil Pump Screen & Pickup Tube Bolts
Courtesy of FORD MOTOR CO.