LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the flexplate. For additional information, refer to Removal and Installation .
  3. Remove the crankshaft sensor ring.
  4. Using the Crankshaft Rear Oil Seal Remover and Slide Hammer, remove and discard the crankshaft rear seal.
    • Clean all sealing surfaces with metal surface prep.
    Fig 1: Identifying Crankshaft Rear Oil Seal Remover And Slide Hammer
    G06061951Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals